Tous vos outils sont à portée de main, on va ouvrir la bête et repérer les composants avant de transformer le circuit.
L'ouverture de la webcam ne pose pas de problème particulier.
Ôtez les 2 vis sous le boîtier.
Retiré le premier cache de la face avant de la webcam. (Celui avec l'inscription Philips)
Puis inséré un tournevis dans les fentes de chaque côtés de webcam.
Identifications des composants:
Les 2 images ci-dessous représentent le côté 'composant' et le côté 'CCD' du circuit de la webcam. Seule la LED (emplacement décrit sur la figure de gauche), doit être supprimée. On peut au choix, soit la dessoudée ou couper les pins.
En effet lors du fonctionnement en mode longue pose, la lumière verte émise par la LED risque de dégrader la qualité des images obtenues par des reflets parasites.
En ce qui concerne le micro, celui-ci ne gêne pas. Il n'est donc pas nécessaire de le dessouder.
Maintenant que les différents composants de la webcam ont été abordés, entrons dans le vif du sujet: la préparation du CD4011. L'introduction de ce circuit est la base même de la modif. Il permettra, via le port parallèle d'un PC de commander le temps de pose de chaque image.
Pas de panique, ce montage n'est pas réellement compliqué. Il va nous mettre en confiance pour la suite des opérations...